Is Your Nautique LINC Blacked Out or Stuck on Booting? Here Is How to Remove and Fix It
Is Your Nautique LINC Blacked Out or Stuck on Booting? Here Is How to Remove and Fix It
A black screen or a display frozen on the booting page is one of the most common HV700 failures we see on 2012 and 2013 Nautiques. Here is why it happens, how to remove the display from your dash, and how our standard mail-in repair brings it back.
What Is the LINC 2.0 Display?
The 7 inch helm display behind Nautique's LINC 2.0 system
The LINC 2.0 display on 2012 and 2013 Nautique boats is a 7 inch Murphy/Enovation HV700 unit, framed by the rubber buttons on your dash. It runs your gauges, speed control, ballast, audio, and system settings, so when it goes dark or hangs on the booting page, you lose the heart of the helm.
The same HV700 hardware sits behind the displays on Supra, Mastercraft, Tige, Centurion, Regal, and many other boats from the same era. That is why this failure shows up across so many brands, and it is also why we see it in our shop every single week.
The Failures We See Most
Stuck on booting and blackout lead the list on this display
Stuck on the Booting Page
The display powers on, the booting text appears, then it hangs there indefinitely. Restarting the boat or resetting the battery tends to leave it unchanged.
Black Screen
The display looks completely dead even though it has power. In many cases the unit is actually still running behind a dark screen.
Faint, Barely Visible Image
The booting text or graphics are so dim you can only spot them at an angle or with a flashlight. Owners frequently mistake this for a dead unit.
LCD Stripes, Spots, or Burn
Vertical stripes, dark blotches, or sunburned patches on the image that have been known to spread over a season or two.
Why It Happens
Years of heat, sun, and vibration take a toll inside the display
A helm display lives a hard life. It bakes in direct sun, cycles through heat and cold, and takes constant vibration from the water. After years of that, the internal display components and control electronics on the HV700 have been known to fail, and when they do, the unit can hang on the booting page or drop to a black screen even though the rest of the boat is perfectly fine.
It is a hardware failure inside the display itself, which is why software resets, battery disconnects, and fuse checks tend to leave the symptom exactly where it was.
How to Remove Your LINC 2.0 Display
No special tools or dealer visit required
Getting the LINC 2.0 out of your Nautique dash takes a Phillips screwdriver and a few minutes. Here is the whole process.
- 1Remove the visible screws holding the tray into your dash, shown above.
- 2Tilt the display panel forward out of the dash so you can reach the back of the unit.
- 3Disconnect the black and grey plugs from the back of the display.
- 4Remove the 4 Phillips screws to separate the LINC display unit from the tray.
This Failure Is Very Common, and We Have the Fix
Covered by our standard mail-in repair, no special tier needed
If your LINC 2.0 is stuck on booting or showing a black screen, you can rest easy. This is one of the failures we repair most often on the HV700, and it is fully covered as part of our standard mail-in repair service. There is no special tier and no guesswork.
We replace the defective OEM components with brand new parts, test the unit thoroughly, and ship it back working, with your settings intact and nothing to reprogram. Turnaround is 3 days or less once it arrives.
Why Our Repair Outlasts the Original
Brand new parts, upgraded beyond the OEM design
The original 2013 LINC 2.0 display has been discontinued at the dealer level and superseded by newer part numbers, so a full replacement is often a special order at a steep price. Our repair keeps your original unit and brings it back better than it left the factory.
How to Get Started
Order the repair or match your exact unit first
Mail-In Repair
Send us your HV700 with the prepaid label. We repair the stuck-on-booting or black screen failure with brand new parts and ship it back working.
Start Mail-InMatch Your Display
Browse the 2012 to 2013 Nautique LINC 2.0 collection to confirm your exact display version before ordering.
Browse the CollectionGet Your LINC 2.0 Off the Booting Page
Black screen and stuck-on-booting failures are what we fix every day. Send in your HV700 and get it back at the helm, fully working, in 3 days or less.
Start Your Repair